| TEL: (800) 422-4231 | A division of Letters Unlimited Inc. | FAX: (800) 310-1557 |
| Home Clip art Order Online! FAQs Privacy policy sales@signbanners.com |
Self-assembly Instructions
Surface preparation
All surfaces must be considered dirty and must be cleaned prior to the application of markings.
Clean the area where the markings are to be applied with a household cleaner, 409, Windex or equivalent will do. We recommend an alcohol based cleaner such as denatured alcohol or equivalent. Banner surface should be dry before proceeding.
Temperature requirements
Air and application surface temperatures must be above 40 degrees.
See Alternative instructions for horizontal hinge method.
Step-by-step instructions:
 1.) Assemble required items. Blue squeegee supplied free with all banner self-assembly orders. |
 |
 2.) Clean banner. |
 3.) Measure equal spacing top, bottom, left and right. Measure twice. |
|
 4.) Apply masking tape to top and bottom of application in center to begin center hinge application. Double-check copy and measurements before proceeding. |
 5.) Fold copy back and apply gentle crease, near center hinge. |
|
 6.) Pull release liner away from application tape and legend until close to hinge. |
 7.) Cut release liner with scissors and discard. |
|
 8.) Squeegee exposed half of legend, holding the end up and allowing the squeegee to cause contact. |
 9.) Same as Step 8. |
|
 10.) Remove tape, fold back onto itself and remove release liner. |
 11.) Squeegee exposed half of legend, holding the end up and allowing the squeegee to cause contact. |
|
 12.) Completely squeegee entire copy with force. |
 13.) Remove application tape by pulling it back onto itself. Be careful not to pull letters up. They may tend to stick to application tape so take your time. Discard tape. |
|
 14.) Same as step 13. |
 15.) The assembled banner. |
|
| Home Clip art Order Online! FAQs Privacy policy sales@signbanners.com |
Copyright © 2003 Letters Unlimited, Inc., All Rights Reserved |