TEL: (800) 422-4231 A division of Letters Unlimited Inc. FAX: (800) 310-1557 Home       Clip art       Order Online!       FAQs       Privacy policy       sales@signbanners.com Alternative lettering installation instructions Center Hinge Method Figure 1    Figure 2    Figure 3    Figure 4      Position legend with tacks (small pieces of masking tape). See figure 1 Apply masking tape vertically through center of legend. See figure 2 Remove tack from one end, lay legend over towards center tape hinge. Pull release liner away from application tape and legend until close to hinge. Cut release liner with scissors and discard. Squeegee down exposed half of legend, holding the end up and allowing the squeegee to cause contact. Remove the tack hinge and lay the other half over. Remove the rest of the release liner and squeegee into place. Remove application tape. Horizontal Hinge Method Position legend with tacks (small pieces of masking tape). See figure 1 Apply masking tape horizontally across top of legend.ð See figure 3 Remove both tacks. Cut legend into smaller areas (vertically between letters). See figure 4 Starting at right (if right handed), flip one section over and release liner. Wipe sign surface free of dust (which may have come from back of legend). Squeegee into place using one smooth downward stroke.ð Repeat for balance of legend. Re-squeegee using more pressure. Remove application tape. Home       Clip art       Order Online!       FAQs       Privacy policy       sales@signbanners.com Copyright © 2004 Letters Unlimited, Inc., All Rights Reserved